Push the odometer reset button again to view additional codes if they exist.Ĩ - If DTC's are not to be cleared, Press and release the odometer reset button. If there are any DTC's the code will be displayed or the word "none" will appear if there are no DTC's. S = TSM/TSSM (Turn Signal/ Security Module)Ħ - To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. P = ECM/ICM(Electronic Control Module) /Ignition Control Module) (from P to S to SP to t and back to P, etc.) To move from one letter (module) to the next, you push the odometer reset button one time.
The module that is flashing is the one you are going to check. The word "diag" should then appear.Ĥ - Push the odometer reset button once and you will see the selection menu "PSSPt" with the first P flashing.ĥ - Each letter represents an area of the diagnostics module. Background lighting should illuminate, speedometer needle should sweep its full range and indicator lamps (battery, security, low fuel, check engine and cruise) should illuminate. For 2014 & newer touring models this will be the toggle switch on the left control mount.ģ- Turn ignition switch to Ignition and release the odometer reset button.
The following procedure will instruct in retrieving and clearing ECM Diagnostic Trouble Codes and TSM/TSSM codes through the Harley gauge cluster as well as a list of codes.ġ- Turn Ignition switch to OFF & Run/Stop switch is to Run.Ģ- Push odometer reset button in & hold. Fuel Moto does not offer technical support for diagnostic trouble codes. DISCLAIMER: this information is for reference only.
0 kommentar(er)
